"Boot in Safe Mode DSREPAIR" initialization process can be applied to Windows XP, Vista, and 2008, and Windows 7, and 8 Blue Screen of Death (BSOD) errors. When the BIOS (Basic Input / Output System) configuration of this error and supported operating system ACPI (Advanced Configuration and Power Interface) is not compatible with the standard. It will cause the computer to start in safe mode, in order to prevent damage and data loss perform automatic shutdown.
This blue screen error is caused by hardware, peripherals, and is not compatible with the operating system device drivers.
This is also known as the blue screen error "BOOTING_IN_SAFEMODE_DSREPAIR" and "STOP 0x000000AA" Windows operating system, some users report this error, it is usually during initialization system appears on the screen.
To solve the "boot in safe mode DSREPAIR" blue screen error in Windows 7, you must start with SATA (Serial Advanced Technology Attachment) to adjust the BIOS IDE (Integrated Drive Electronics) mode. The SATA and ATA is connected to the computer's hard drive to the motherboard, and IDE is a standard electronic interface to connect to a disk storage interface on the motherboard.
To enter the BIOS setup, start or restart the computer, wait for the "input settings" message appears for a few seconds, including the key to enter the BIOS. Quickly press to enter the BIOS setup and navigate to the key to disable the SATA options. Save the BIOS options, and then restart the computer to test a blue screen error has been resolved.
You can also undo the recent changes in the computer, such as installing new programs, drivers, and equipment to solve this blue screen error. Uninstall procedures and equipment recently installed, then restart the computer to check if the blue screen error has been resolved.
As always, please leave any comments or questions below in the comments section or ask us a question, the answer ReviverSoft .
0 komentar