Win 7 Computer Blue Screen When Installing Xp System Change Solutions

The system now Lenovo is the basic pre-installed WIN7, a lot of friends because of various reasons, need to put the system into XP, but a blue screen during installation, the following'll tell you the solution. Because now are basically computers with SATA hard drive, and XP system ...

　　Lenovo is now the basic system is pre-installed WIN7, a lot of friends because of various reasons, need to put the system into XP, but a blue screen during installation, the following'll tell you the solution.

　　Because now are basically computers with SATA hard drive, while XP installation disk system because there is no SATA controller drivers, will result in a blue screen during installation, there are two ways to solve this problem.

　　First, change the BIOS settings in the hard mode:

　　1, start clicking F2 to enter the BIOS setup.

　　2, select the configuration, the SATA Mode is set to IDE can.

　　3, press F10 to save and exit the BIOS settings, restart the computer after you can install the system properly.

　　Second, the use of integrated SATA controller driver installation disk

　　You can use this site to provide the "Lenovo OEM XP SP3" system that integrates the latest SATA drives, and the latest patch, you can directly install the system without change BIOS settings. It is strongly recommended that you use this method, because if you use the first method, it will reduce the efficiency of the hard drive, you can not play the advantages of SATA hard drives.